54
TESTING TRAINING FUNCTIONS
NOTE
-
Before testing, make sure that all units are fully charged and the
handheld unit and collar unit(s) are ON. If the collar unit being tested is
not displayed on the handheld unit, the collar unit must be added to the
handheld unit (
see pg. 63
). If the collar unit appears gray on the screen,
the collar unit is OFF.
WARNING
- Do not perform testing while your dog is wearing the
collar unit. Use the Test Lamp for testing.
To Test the Remote Training Functions:
1. Place the test lamp firmly on the contacts of the Collar Receiver.
2. Set the intensity level to 10 or greater (lower levels may not activate
the lamp).
3. Press the Nick (‘N’), Continuous (‘C’), Jump (‘J’), or Rise (‘R’) buttons.
The test lamp will flash when stimulation is activated. (lamp will be
brighter at higher intensity levels).
4. Press the Vibrate (‘V’) button. The collar unit should vibrate.
NOTE
- If you have more than one collar unit programmed to your
handheld unit, press Dog (‘D’) to switch collar units and repeat the
procedure.
Содержание Border Patrol TC1
