5
Transportation
Slide the lock pins to lock the cutting
head when the cutter is not use to keep
the blade in a close position for the
safety as shown on top illustration.
Pull out the carry handle while the lock
pins are released as shown on bottom
illustration.
Changing the Blade
First loosen the two screws on the blade
and remove the stopper screw holder
and pull out the blade as shown. Use
provided Allan wrench to remove the
nine screws, then carefully move the
blade out of the small blade holder.
Note:
the flat side of the blade should
face the working table.
Warning:
Do not put your fingers
against the sharp edge of the blade at
any time.
Notch Cut
Make a lengthwise cut first to the
desired length on the floor plank as
mentioned above, then turn the
plank 90°, and put desired cutting
point under the blade.
Unlock two screws on the blade
holder and pull out the blade as
shown to above mentioned desired
cutting point, then pull the handle
down to complete a cut.
