Cyrus IIIi, Инструкция пользователя

Страница: 6 / 12

Cyrus llli User Instructions
4
G B
G B
TROUBLESHOOTING GUIDE
If your Cyrus IIIi is not operating properly, disconnect the power and
check carefully all connections.
If you are in any doubt, consult your dealer.
No sound
Amplifier switched off or in Standby Bring unit out of Standby
(Standby light - GREEN)
Mute is on (RED light on Vol. Ring) Deselect Mute
Tape Monitor on(RED tape light) Operate Source
Source not working
(e.g. CD not playing) See ‘Fault Indication System’
No sound from one loudspeaker
BAL control at extreme limit Centralise Balance
Does your speaker have fuses? Check speaker, replace fuses
Speaker cables / interconnects faulty Check connections, cables -
replace if needed
Spurious noises from speakers
Interconnects or connections faulty Check, replace where necessary
Phono Ground not connected Make sure ground wire is firmly
connected
No response from any keys
Switch off at rear panel, wait one minute and switch on.
The problem should clear
The Cyrus IIIi has a unique fault indication system to help you to
diagnose problems. All fault indications appear on the Standby light on
the front panel.
Fault indications at first installation of a Cyrus IIIi with a PSX-R
Flashing Red
The Cyrus IIIi is modified for
PSX-R but the PSX-R is not
properly connected Check PSX-R is plugged into
Cyrus IIIi and that both units are
connected to the mains
Flashing Green
A PSX-R is connected to a Cyrus
IIIi which has not been modified to
take the PSX-R Unplug PSX-R, check Cyrus IIIi. If
Cyrus IIIi works OK, return to
dealer for modification
Fault Indications during use
Flashing Green and Yellow
An overload condition usually
caused by excessive level or a
problem with your loudspeakers Reduce level or Unplug speakers
amplifier should restore
Flashing Green
A fault condition has been reported
from the PSX-R Switch off power to both units, wait
one minute, switch on - amplifier
should restore
Flashing Red
An internal problem with Cyrus IIIi
or PSX-R Switch off and on - amplifier should
restore
Remote control not working
Remote control not operating Check batteries
Remote control will not operate a
Cyrus CD player or tuner CD or TU button must be pressed
before sending a command
If a fault condition still remains, return the Cyrus IIIi (together with the
PSX-R if you are using one) to your Cyrus appointed dealer or an
authorised Service Centre.
WARRANTY
SPECIFICATIONS
Power Supply
Voltage: ................................................................... As plate on rear of unit
Power Consumption
Standby ..............................................................................................(12W)
ON (No Load).....................................................................................(23W)
ON (2 x 50W/Ch)..............................................................................(185W)
Safety Requirements.........................................................CE, CSA and UL
Enclosure
Dimensions (WxHxD).....................................................215 x 75 x 365mm
Weight ................................................................................................ 4.6Kg
Material.............................................................................. Die cast chassis
Audio Performance
Input Sensitivity (50W/8
Ω
).......................... Line ............................. 200mV
Phono......................... 2.75mV
Input Impedance ......................................... Line ............................... 50k
Ω
Phono................... 47 k
Ω
/50pf
Frequency Response (-3dB)....................... Line ................... 4.5Hz, 80kHz
RIAA accuracy............................................. Phono........................+/-0.2dB
Signal to Noise Ratio (A-WTD) ................... Line ............................107dBA
Phono.................. 83dBA/5mV
Power Output (both channels driven).......... 8 Ohms ........................... 50W
THD+N (Pre-Amp) 1kHz ............................. Line .......................... <0.004%
Phono........................... 0.01%
THD+N (1kHz, 2/3 power)........................... 8 Ohms .................... <0.005%
(both channels driven)
Cyrus reserves the right to change all specifications without notice. E &OE
The warranty card enclosed should be completed by the Dealer and the
purchaser and returned to CYRUS or its Distributor within 8 days of
purchase. No Dealer or Distributor may vary the terms of this warranty,
which is personal to the original Purchaser and is not transferable.
Please retain the sales receipt as proof of purchase.
Warranty claims must wherever possible be made through the Dealer
from whom the equipment was purchased.
This warranty excludes:
•
Damage caused through neglect, accident, misuse, wear and tear,
or through incorrect installation, adjustment or repair by
unauthorised personnel. Any unauthorised servicing will result in
loss of warranty.
•
Liability for damage or loss occurring in transit to or from the
purchaser.
•
Consequential damage, loss or injury, arising from or in conjunction
with this equipment.
Equipment for attention under warranty should be consigned return
carriage paid. If returned equipment is found to comply with the
published specification, CYRUS reserves the right to raise a charge.
The above conditions do not affect your statutory rights as a consumer .