MB95560H/570H/580H Series MB2146-510-01-E Setup Guide, Doc. # 002-05587 Rev. *A
20
EV board Introduction
Table 3-1. Power Supply Selection
BGMA Interface
To start the debug using a BGMA, users shall connect IDC10 socket from the BGMA to CN1 on an
EV-board, and J2 shall be closed to enable reset key S3.
Figure 3-4. Debug Interface.
Table 3-2. J2 Setting
This setting is effective just when BGMA (MB2146-07-E) is connecting to STK board (MB2146-510-
E). The other BGMA circuit is different from MB2146-07-E. When STK board connects to other
BGMA that may broke the MCU of STK board, so please use the products in this package. For the
package information please refer to “1.1 Objective and Deliverable”.
Power supply
Header name
Settings
4 AA batteries from BT1 on
the back of the EV-board.
J1: BAT.
9V DC from CN6
J1: 9V.
MCU Mode
Header name
Settings
Debug, normal mode
J2
BAT.
9V
J1
BAT.
9V
J1
CN1
J2
S3
J2
