MB95560H/570H/580H Series MB2146-510-01-E Setup Guide, Doc. # 002-05587 Rev. *A
21
EV board Introduction
Clock Settings
The MB95560H/570H/580H series MCU uses an internal main CR as a clock source by default.
Users can select on-board crystal as a main clock and a sub-clock. Follow the settings below:
Table 3-3. SW3 Setting
Buzzer Module
A buzzer module is provided to demonstrate an 8/16 composite timer output (a continuous mode).
To enable buzzer module, follow the table below:
Table 3-4. SW1 Setting
A/D Module
VR1 and VR3 are to demonstrate a MCU A/D converter usage. Select VR1 or VR3 by the following
table.
VR1 is connected to MCU A/D channel 1, and VR3 is connected to MCU A/D channel 0.
Clock
Header name
Settings
Main clock
SW3: X1, X0
Sub-clock
SW3: X1A, X0A
Modules
Header name
Settings
Buzzer:
BUZ1
SW1: BUZ.
SW3
SW3
SW1
LED4 BUZ
