Setting up the Emulation System
F2MC-16FX Family, Emulator System MB2198-01 Installation Guide, Doc. No. 002-05547 Rev. *A
11
3.1.6
Insert the Evaluation Chip
First, push down the outer frame of the BGA
socket of the Adapter Board. Near one corner is
a small triangle, which points to Pin 1 of the chip
socket.
The Evaluation Chip has one flat corner. This
indicates the Pin Position 1.
Then insert the Chip as shown in the right
picture and release the frame.
3.1.7
Connect the Probe Cable to the Adapter Board
Connect a Probe Cable to the bottom side of the
Adapter Board. For e. g. MB96F348 use the
QFP100 NQPACK PROBE cable (MB2198-501).
The cable has to insert in the FLAT CN A (CN3)
and FLAT CN B (CN4) connectors on the Adapter
Board.
3.1.8
Connect the Emulator System with the Starter Kit
Connect the Probe Cable to a Starter Kit (e. g.
FLASH-CAN-100P-340).
Insert the cable properly into the MCU socket on the
Starter Kit Board. Note, that it fits only in the correct
position: Three edges of the socket are round and
one is flat. In addition both the probe socket and the
Board
have
small
triangles
which
point to
Pin 1.
After inserting, use a small cross tip screwdriver to fix the four screws of the probe cable.
