Getting Started With EZ-
BLE™ PRoC™ Module
www.cypress.com
Document No.: 001-96841 Rev. **
45
7. When the pin assignment table is displayed, you will notice that two of the connections have been unassigned. This is due
to the limited I/O supported on the EZ-BLE PRoC Module. Both
‗Disconnect_LED‘ and ‗Wakeup_SW‘ will be shown as
unassigned.
8. To complete the assignments, assign P3[4] to
‗Disconnect_LED‘ and P3[5] to ‗Wakeup_SW‘. These connections can be
determined through checking the CY8CKIT-042-BLE and CYBLE-022001-EVAL schematics.
9. Build the application as shown in
Figure 54
.
10. Program the CYBLE-022001-EVAL as shown in
Figure 57.
11. Proceed to the next section to test your design.
