Getting Started With EZ-
BLE™ PRoC™ Module
www.cypress.com
Document No.: 001-96841 Rev. **
26
7. You can see pre-populated Components in the schematic as
Figure 28
shows.
Figure 28. Pre-populated Components
8.
Disable/enable the Components per your design
. For this design, right-click on each of the components as follows and
enable/disable components/features as
Figure 29
shows:
Disable ADC_SAR_Seq_1 and ADC_In from the BATTERY MONITOR section
In the GPIO BUTTONS section, disable all buttons except SW1
In the TIMER section, disable TCPWM_1, Clock_1, and ISR_1
Disable Capsense_1, from TOUCH PAD section.
Disable SCB_1 and SCB_2 from the Serial Interfaces section (I2S_1 should already be disabled)
Instead of disabling, deleting the unused Components is also possible. These components have an option of bringing back
from Component Catalog if required.
