CY14NVSRAMKIT-001 nvSRAM Development Kit User Guide, Doc. # 002-03522 Rev. *A
25
Kit Operation
Figure 4-9. FM4 MCU Evaluation Board Jumper Setting in Run Mode
Figure 4-10. FM4 MCU Evaluation Board Setup in Run Mode
LED2 and LED5 turn green to indicate the board is powered from the USB port via the CN4
connector. LED3 is off indicating the board is powered in the Run mode. After connecting the FM4
MCU Evaluation Board to your PC through the USB port (CN4), wait for drivers to install. When
drivers are successfully installed, follow the steps in
4.3 Spansion Virtual Communication Port Driver
Installation
to verify or install the Spansion Virtual Communications Port driver. Connecting the FM4
MCU Evaluation Board USB port ‘CN4’ to the PC should recognize the port as a ‘Spansion Virtual
Communications Port’.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from