CYP IP-7000TX, Инструкции по эксплуатации

Страница: 35 / 44

35
Video over IP
This section allows control over many critical functions of the Transmitter
including: selection of the input source, enabling/disabling the VoIP
stream, enabling access to the Video Wall tab, and controlling the
streaming bit rate and quality.
-
HDMI/VGA:
Switch between the HDMI or VGA input on the
Transmitter.
-
Enable Video over IP: Unchecking this checkbox will disable the
VoIP stream completely. This option should always remain checked
unless troubleshooting is being performed.
- Enable Video Wall:
Checking this box will enable the Video Wall tab
in the WebGUI.
Note: It is not required to enable this on the Transmitter to set up a video
wall. Only Receiver units require this to be enabled.
-
Maximum Bit Rate:
Set the maximum bit rate that can be used by a
single video stream. Available options are: Best Effort, 400 Mbps, 200
Mbps, 100 Mbps, 50 Mbps. Selecting “Best Effort” will use up to the
maximum available bandwidth in order to maintain a full framerate
video stream.
Note: While it is generally suggested to select “Best Effort” when
streaming 4K video sources, the amount of bandwidth required can be
very large and will limit the number of concurrent video streams.
-
Maximum Framerate: Adjusting this slider will set the percentage
of frames from the source video to encode (2–100%). This is ideal for
reducing the bandwidth requirements of high-resolution, but limited
motion, sources such as power point presentations or information
screens.