9
1. Check if the right adaptor is used (5V 2.6A adaptor).
2. Make sure all power connectors are correctly
plugged in.
3. Push the power button to turn on the device.
1. This is normal if the devices are connecting or in
search mode, the LED will slowly turn on when it is
doing signal linking, after that is done and when the
signal is transmitted and received the LED will be
consistent.
2. If the LED keeps on flashing for more than 3 minutes,
then repair the devices by pushing the ID keys for 2
seconds.
3. If the LED is still flashing slowly for more than 3
minutes, then make the input selection of the
Transmitter is correct.
1. Check if the source’s timing is supported by the
device. The device supports up to 1080i so please
make sure the source is sending an acceptable
timing for the device and display and that the
display can also accept that timing.
2. Check if both source and the display are HDCP/CEC
compliant.
3. Check if TV mode is selected instead of HDMI mode.
4. Check if both source and display are connected.
1. When linking for the first time, if the output display
does not link up, the input LED will not switch on, so
please check if the HDMI output is connected.
1. A red Power LED means Broadcast mode and green
Power LED means Unicast mode. If Tx has a Green
LED but Rx has a red LED, press the Rx's ID for 10
seconds to change it to Unicast mode. But when
Broadcast mode is demanded press Tx's ID key for 10
seconds to switch to Broadcast mode.
