5
5. Remote Control
①
.
Power: Press to turn the device on or off.
②
.
ID:Press the transmitters “ID” button and
receiver “ID” button for two seconds to
connect the system. This system was already
connected before leaving the factory so
users don't need to reset it again unless the
system cannot link up properly.
③
.
1~3: Press 1-3 to have your desired input
source be displayed on the HDMI output.
CR-67
ID
POWER
INPUT
1
2
3
Transmitter
①
②
③
6. IR Cable Pin Definitions
Note:
The IR Receiver & Blaster can support a frequency of 36~38KHz with NEC
Code.
6.2. 3.5Ø Connectors Pin Definitions
6.1 IR Blaster
Power 5V
IR blaster signal
IR blaster signal
Pin
1
2
3
Assignment
Power 5V
IR Signal
NC
