CYP CPHD-V4L, Руководство по эксплуатации, Страница: 55 / 76

50
COMMAND
Description and Parameters
$EDID_WRITE N1,N2 N3

Directly write an EDID block to the selected EDID location. The
data must be sent as a 128 byte hex data bit stream following the
<CR><LF> in the N3 part of the command. Each hex data unit is
composed of 3 digits. The first 2 digits are the hex value. The 3rd digit
is a space (0x20).
Available values for N1 :
RX [HDMI Input(Rx) Port]
SINK_H [HDMI Sink]
Available values for N2 :
BLOCK0 [EDID Block 0]
BLOCK1 [EDID Block 1]
N3 = <CR><LF>{data} [128 byte hex data]
Note: If the sum of the 128 byte data isn’t 0, “$err_checksum” will be
displayed.
$FACTORY

Execute a factory reset and reboot the unit.
Note: Stored Copy EDIDs and Ethernet settings will not be reset.
$FWVER?

Show the current firmware version.
$HDCP_IN_SW N1

Enable or disable HDCP support for the unit’s HDMI input.
Available values for
N1 :
ON [Enable HDCP]
OFF [Disable HDCP]
Note: Analyzer mode only.
$HDCP_IN_SW?

Show the current HDCP support setting for the unit’s HDMI input.