Getting Started
Plug in your CTM using either the primary or secondary power supply port. Connect your PC to the “network” port on the front of
the unit via a standard CAT5 cable and your computers NIC card. Once you have established an Ethernet connection, you can
access the web interface at the default IP address
(169.254.1.1)
.
Using the CTM Control Panel, you can now navigate the various configuration and status pages within the CTM user interface.
CTM Main Page
The first page displays the current CTM network settings and readings from the GPS receiver on board.
Basic Information
Site name:
When set, this field will display the name or location entered under the general system setup page.
Date:
Displays the current date when CTM is connected to the GPS antenna, and has proper GPS lock.
Time:
Displays corrected time when CTM is connected to the GPS antenna, and has proper GPS lock. Time correction can be
adjusted to display current time in any time zone from General System Setup page.
Alert:
Displays current state of alarm for quick reference.
MAC Address:
Displays MAC address of CTM. Address is permanent, and can not be altered or changed by the user.
Flash Memory:
Upon startup, the CTM will perform a checksum of the primary memory location containing the user interface
and operating files. In the event that memory location “A” is corrupt, the CTM will boot up using location “B” and display a failed
checksum for location “A”. If both memory banks have been corrupted, the CTM will boot up in Flash Loader mode. In the event
of a simultaneous failure of both memory banks contact Last Mile Gear Technical Support at +1(360) 414-5990 or support@last-
milegear.com.
Password Set:
Displays current state of password security. Password system OFF is default, with no password set. Password se-
curity can be enabled by entering the desired code in the Change Password page. Once set, this field will display CTM Password
lock is ON.
Interface Version:
Shows current version of web interface operating software.
Control CPU:
Shows current version of CPU software load.
Flash Loader Version:
Shows current version of firmware upload software.
Hardware Version:
Shows current version of CTM circuit board.
Radio Power Status:
This window will display the current status of all 8 radio ports
Status:
Here you will find the current state of power for each port. The ON condition will be displayed in green, and shows that
this port is currently being powered. The OFF condition shows that this port is currently not powered and is shown in black. When
this field displays the red TRIP status, the radio port has shorted out causing the CTM to automatically turn off power to this port.
Power can be restored in the CTM Radio Setup page.
Sync:
Displays current state of sync for each port. The ON condition shows that the sync pulse is being fed to the radio connected
to the corresponding port. The OFF condition shows that the sync pulse is disabled and an uninterrupted 24VDC is being fed to
the corresponding radio. Sync can be turned off and on for each port on the Radio Setup page.
Radio Power:
This column will display the current power draw in Watts from each port.
Radio Name:
This column will display the user defined name for each port. The user can edit these fields in the CTM Radio Setup
page.
