15
Cyclone Insert Installation - English
BX212/BX215 INSERT HOOD INSTALLATION
This appliance requires 120V 60Hz electrical supply and
connection to an individual properly grounded branch circuit
protected by a circuit breaker or time delay fuse.
• Turn off power circuit at the service panel before wiring
this unit.
• All electrical work must be done by a qualified electrician
in accordance with all applicable codes and standards.
This range hood must be properly grounded.
WARNING
• At least two installers are required due to the weight and
size of the hood.
CAUTION
Prepare for Installation
1. Unpack range hood and check contents. Note: Be cautious of
sharp edges within the unit.
2. Cut the insert cutout at the bottom of the cabinet using the
given cutout measurements on page 15 (Figure 1).
3. Locate the cutout at the center of the bottom of the cabinet.
Installing the BX212/BX215 Range Hood
Top Panel
Figure 3.
Figure 2.
Figure 4.
1. Remove outer mesh filters of range hood.
2. Attach damper to rectangular cutout on top of the range
hood using the screws provided (Figure 2).
3. Remove the top panel (Figure 3).
4. Hold range hood upright, and insert range hood upward into
cabinet cutout. Mount the insert range hood to the cabinet
using four screws on the left and right sides of the bottom of
the range hood (Figure 4).
5. Reattach and screw top panel onto range hood.
6. Make sure that the adapter is connected to ductwork.
7. Place mesh filters back into place.
8. Connect the power plug to the junction box.
