Page 4 of 5
3.
WallRack
“Strut
-
Mount”
Installation:
A.
Tools & Fasteners
•
3/8” Power Drill
•
1/8” x 3” Long Carbide Drill Bit
•
T-30 Torx Bit {5/16
”
Screw}
•
T-45 Torx Bit {3/8
”
Screw}
•
(9
) 5/16” x 2
-
1/2” Long
Lag
Screws Part # 17505
{Included}
•
(8) 3/8-
16NC X 1”
BHCS
Torx
Screws Part #12724
{Included}
•
(8) 3/8-16NC Zinc
Strut Nuts
Part #17525
{Included}
•
Pencil
•
Tape Measure
•
Stud Finder
•
Blue Line or Laser Level
B.
Installation:
a)
Locate center of studs with Stud Finder for placement of the
U-Strut
Spanners Part #15720
{18
”
Shown as reference only}
b)
Snap a line with the Blue Line or Laser and make a mark with pencil at
approximately 60” from the floor
across the five-foot or ten-foot span you
intend the hang the racks
c)
Next snap second line 12” below the first and a third 12” below the second
d)
Mark with a Pencil the centers of the studs on the snap lines
e)
Now drill approximately 2-
1/2” deep into drywall and stud with 1/8” x 3”
Drill Bit on centers of the Pencil Locations
f)
Align a
U-Strut #17520
Spanner Slots and Level the Spanner, then with the
Drill & T-30 Torx Driver screw the
Lag Screws #17505
into the slot and wall
till tight, and repeat for each of the remaining spanners
g)
Now place the
WallRacks #17502
over the spanners on approximately 16”
centers staggered on 12” offset as shown below
