Page 2 of 5
2.
WallRack
“Angle
-
Bracket”
Installation:
A.
Tools & Fasteners
•
3/8”
Impact Drill
•
1/2
” x 3” Long
Carbide Drill Bit
•
(2) 5/16”
Lag Shields
Part #17504
{Included}
•
(2) 5/16” x 2
-
1/2” Long
Lag
Screws Part #17505
{Included}
•
T-30 Torx Driver {5/16
”
Screw}
•
T-45 Torx Driver {3/8
”
Screw}
•
(2) 3/8-
16NC X 1”
BHCS
Torx Screw
Part #12724
{Included}
•
(2) 3/8-16NC Serrated
Flange Nut
Part #12688
{Included}
•
Pencil
•
Hammer
•
Tape Measure
•
9/16” Hex Wrench
•
Concrete Adhesive
•
Blue Line or Laser Level
B.
Installation:
a)
Locate center of bottom hole placement of the first WallRack
b)
Snap a line with the Blue Line or Laser and make a mark with pencil at
approximately 60” from the floor to the first mounting hole position
c)
Hold rack straight and center hole over mark position, the bottom hole and
mark the upper hole at 12” center to center, which would be the 1st
hole
down from the top
d)
Remove rack and drill approximately 2-
1/2” deep into concrete with 1/2” x 4”
Drill Bit on center
e)
Squirt in some Concrete Adhesive in both holes
f)
Insert the
(2) Lag Shields #17504
into the holes and tap flush with the hammer
