Troubleshooting
N
No
o d
diissp
plla
ay
y o
on
n c
co
om
mp
pu
utte
err ssc
crre
ee
en
n
· Computer is asleep – Press [MODE] or [SELECT] on the computer to wake up the computer.
· Batteries need replacement - replace the computer batteries as shown on pages 14-15 of the
User Manual.
· Computer is too cold- operating temp. is 32 to 110 degrees Fahrenheit
C
Co
om
mp
pu
utte
err d
diissp
plla
ay
y iiss o
on
n,, b
bu
utt tth
he
erre
e iiss n
no
o ttrra
an
nssm
miissssiio
on
n iic
co
on
n
· Hub is asleep - spin the wheel to wake up the hub.
· Batteries need replacement - replace the hub batteries as shown on page 34 of the
User Manual.
· Does the word “watts” appear under the top line? If no than you have entered cycle computer
mode. See
cycle computer mode
for further instructions.
· Computer not seated in mount - make sure computer is firmly and correctly mounted in
handlebar mount.
· Moisture in hub - remove cover to see if there is any condensation on the battery cover. If there
is, leave cover off in a dry place for 12 hours or until moisture disappears.
· Interference with other devices - make sure you are not setting up the PowerTap inside a
building with a lot of electrical noise, neon signs, or near power lines. Bring the PowerTap out
side or away from the electrical disturbance to see if signal returns. Also make sure you don’t
have any other devices on your bike such as lights, magnets or cycle computer sensors.
· PowerTap computer’s batteries are low, replace batteries as shown on page 34 of the
User Manual. We recommend using a Cone Wrench to remove the battery cap, not a coin.
·· D
Diissp
plla
ay
ye
ed
d d
da
atta
a b
blliin
nk
kss o
orr d
do
oe
ess n
no
ott ffu
un
nc
cttiio
on
n
· Batteries need replacement - replace the computer batteries as shown on pages 34 of
the User Manual.
· Computer not seated in mount - make sure computer is firmly and correctly mounted in
handlebar mount.
· Interference with other devices - make sure you are not setting up the PowerTap inside a
building with a lot of electrical noise, neon signs, or near power lines. Bring the PowerTap
outside or away from the electrical disturbance to see if signal returns. Also make sure you don’t
have any other devices on your bike such as lights, magnets or cycle computer sensors.
38
Содержание PowerTap
Страница 1: ...PowerTap SL2 4 OWNER S MANUAL ...