Joule 2.0 User Guide page 55
Chapter 7: Setting Up CycleOps Joule 2.0
Roll Down Calibration for CycleOps PowerBeam Pro Trainer...
continued
8. Once selected, the roll down calibration process will begin with instructions to pedal at 18 mph.
9. Once at 18 mph, hold this speed for two minutes. A count down timer displays your remaining time.
10. After two minutes, immediately stop pedaling and allow the bicycle wheel to coast to a complete stop.
11. Do not touch or disturb the resistance unit while coasting. Do not pedal or apply the brakes while coasting.
12. After the resistance unit comes to a complete stop, a “Calibration Passed” message will be shown. Note: if
you do not wait the full two minutes or another issue occurs during calibration, a “Calibration Failed” message
will be shown and calibration must be repeated. Note: If calibration continues to fail, contact Saris Cycling
Group at 1-800-783-7257.
13. The unique rolling resistance calibration is now incorporated into the factory calibration. This calibration will
remain in the system until another calibration is performed.
Roll Down
>
Manual
>
Reset to Defaults
>
Sensor ID
Sensor ID
The Gun Show
>
Torque Offset
>
Manual Calibration
>
Torque Offset
>
Back
Report
Main
Calibration
Pedal to 18-22 MPH
>
XX
Hold for (sec):
XXX
Current Speed:
XX.X
>
Torque Offset
>
Manual Calibration
>
Torque Offset
>
Pair
>
Completed
>
Back
<
Report
Main
Roll Down
