Manual of ALT382
7
Install & Test
Only trained technicians are authorized to carry out installation.
Before install, confirm the machine was stay in a solid & smooth place without electromagnetic radiation.
Installed as stipulated in manufacturer
’s specification, do not change the relative position of ink system and
print head. Any special requirements, please consult the manufacturer and supplier directly.
Ink-jet Printer Installation & Testing
Photo1
1
、
Unpacking: open the package and move out printhead, host machine, suspension pad etc.
2
、
Suspension Pad Installation: 1) fix pads into triangle stands in the same height. 2) Adjust the three pads
so as to keep the triangle stand in vertically. 3) Fasten the three screw nuts by spanner.
3
、
Host Machine Installation: 1) Put small steel pipes into large ones and put large steel pipes into triangle
stands, after adjusted the height, fasten the star-shape holders. 2) Put the host machine onto the
adjusted stands and collimate each other. 3) Fasten the host machine to the stands by screws.
4
、
Ink-container Stand Installation: (only effective in independence ink-system): 1) Put small steel pipes
into large ones and put large steel pipes into triangle stands, after adjusted the height, fasten the
star-shape holders. 2) Penetrate the large/small aluminum block into circle pipe, and then fastened in
suitable height.
5
、
Printhead Installation: 1) put the aluminum stick into the two-hole aluminum stand, and fastened by
starlike screw. 2) Screw the printhead on aluminum stick. 3) Connect one side of ink tube to filter and
the other side to ink inlet.