CYBEX 600T, Руководство по обслуживанию

Страница: 44 / 55

Page 5-22
Cybex 600T Treadmill Service Manual
B. Unplug the treadmill from the power outlet.
2. Remove the console back.
A. Remove the eleven Phillips head screws on the console back. Leave the top screw
which holds the accessory holder in place. The top screw will keep the accessory
holder in place on the console back. Set the console back and screws aside. See
Figure 15.
3. Remove the Polar board.
A. Remove the front sensor plate. There is no hardware holding it in. See Figure 16.
B. Disconnect the Polar cable from the upper display board. Remove the Polar board
with its foil, foam and cable. There is no hardware holding the board in place.
4. Attach the Polar board.
A. Connect the Polar cable into its port on the upper display board. Arrange the cable
as shown in the illustration. Place the Polar board in position. See Figure 16.
B. Place the front sensor plate in its position over the Polar cable. There is no
hardware holding it in. See Figure 16.
5. Attach the console back.
A. Attach the console back and accessory holder with the eleven screws.
Upper Display Cable
NOTE: This procedure will cover the upper and lower display cables.
Tools Required
• Phillips head screwdriver
• Needle nose pliers
1. Tum the power off.
A. Turn the main power switch in the front panel to the off (0) position.
B. Unplug the treadmill from the power outlet.