Copyright © 2012 CyberPower Systems, Inc.
IMPORTANT SAFETY INSTRUCTIONS
1
Save These Instructions! This manual contains important constructions that shall be followed during the installation and maintenance of the CyberPower Grid
Tie Solar Inverter.
CAUTION!
Before installation and using the Inverter, read all
instructions and cautionary markings on the inverter and appropriate
sections of this guide.
CAUTION!
To reduce risk of fire hazard, do not cover or obstruct the
heat sink.
CAUTION!
Observe the clearance recommendations. Do not install the
Inverter in a zero-clearance or non-ventilated compartment. Overheating
may result.
CAUTION!
Use only accessories recommended or sold by the
manufacturer. Doing otherwise may result in a risk of fire, electric shock,
or injury to persons.
CAUTION!
To avoid a risk of fire and electric shock, make sure that
existing wiring is in good condition and that wire is not undersized. Do not
operate the Inverter with damaged or substandard wiring.
CAUTION!
Do not operate the Inverter if it has received a sharp blow,
been dropped, or otherwise damaged in any way.
CAUTION!
Do not disassemble the Inverter. It contains no
user-serviceable parts. Attempting to service the Inverter yourself may
result in a risk of electrical shock or fire and will void the factory warranty.
CAUTION!
To reduce the risk of electrical shock, disconnect both AC
and DC power from the Inverter before attempting any, maintenance or
cleaning or working on any circuits connected to the inverter. Turning off
controls will not reduce this risk. Internal capacitors remain charger for 5
minutes after disconnecting all source of power.
CAUTION!
The Inverter must be connected to an equipment-grounding
conductor directly or via the AC ground.
ATTENTIO:
Risk of burning: During operation the case temperature
may exceed 140
℉
(60
℃
) , do not touch.
HIGH VOLTAGE:
Before opening the device, disconnect from the grid
and the PV generator. The device may only be opened by an electrician.
The following conventions are used in this guide.
WARNING!
Warnings identify conditions that could result in
personal injury or loss of life.
CAUTION!
Cautions identify conditions or practices that could
result in damage to the unit or other equipment.
IMPORTANT:
These notes describe things which are important for you to
know, but not as serious as a caution or warning.
About This Manual
This purpose of this Installation & Operation Manual is to provide
explanations and procedures for installing, operating, maintaining, and
troubleshooting the CyperPower Grid Tie Solar Inverter.
Scope
This manual provides safety guidelines, detailed planning and setup
information. It provides procedures for installing the inverter and
information about operating and troubleshooting the unit. It dose not
provide details about particular brands of photovoltaic (PV) panels. You
need to consult individual PV manufacturers for this information.
Audience
This manual is intended for anyone who needs to install and operate the
inverter. Installers should be fully educated on the hazards of installing
electrical equipment. Certified electricians or technicians are
recommended.
Abbreviation and Acronyms
AC:
Alternating Current
DC:
Direct Current
LCD:
Liquid Crystal Display
LED:
Light Emitting Diode
MPPT:
Maximum Power Point Tracking
PC:
Personal Computer
PV:
Photovoltaic
PWM:
Pulse Width Modulation
Vac:
Volts AC
Vdc:
Volts DC
V
MP
:
Voltage at Maximum power
V
OC
:
Open Circuit Voltage
!
!
