Setting Up the V2 Paging Server
Configuring the V2 Paging Server
CyberData Corporation
930367H
Operations Guide
16
2. On the
Device Configuration
page, you may enter values for the parameters indicated in
Table 2-6
.
3. After changing the parameters, click the
Save
button.
Table 2-6. Device Configuration Parameters
Web Page Item
Description
Miscellaneous Settings
Beep on Initialization
When selected, you will hear a beep when the speaker initializes.
Enable Line In to Line Out
Loopback
When selected, audio is sent from the line -in to the line-out output.
Enable Line-In to Multicast
When selected, the line-in audio will be multicast to the address and
port specified on the web page.
Note
: Ideally, the specified address and port will match that of a low
priority MGROUP (such as background music) on the speakers or
paging amplifiers.
Note
: When line-in to multicast is selected, do not set that multicast
address and port to the same multicast address and port that is used
by one of your PGROUPS. Otherwise, when you call the PGROUP,
the Paging Server will be unable to send the new audio stream
because the port will already be in use by the line-in to multicast
stream.
Click the
Save
button to save your configuration settings.
Note
: You need to reboot for changes to take effect.
Click on the
Test Audio
button to do an audio test. When the
Test
Audio
button is pressed, you will hear a voice message for testing the
device audio quality and volume.
Click on the
Reboot
button to reboot the system.