Installing the SIP Paging Amplifier
SIP Paging Amplifier Setup
Operations Guide
931156K
CyberData Corporation
14
High Power Mode
(Two Speakers)
The following figure illustrate how to connect the SIP Paging Amplifier and use the amplified outputs
in high power mode to two speakers or horns.
Figure 2-8. Using the Amplified Outputs—High Power Mode with Two Speakers
802.3at PoE Injector
(high power mode)
or
Note
: You can use an
802.3at compliance
switch or an 802.3at
power injector and hub.
802.3at Compliant
PoE Ethernet Switch
(sold separately)
(sold separately)
Mono(+)/Left Spkr (+) - 12
Left Spkr (-) - 11
Right Spkr (+) - 10
Mono(-)/Right Spkr (-) - 9
Line-Out (+) - 8
Line-Out (-) - 7
Line-In (-) - 6
Line-In (+) - 5
Relay COM - 4
Relay NO/NC - 3
Door Sense/Button Common (GND) - 2
Door Sense/Button Contact (+) - 1
CLASS II WIRING
+
Note
: Horn is connected to terminal
block pins 9 (-) and 12 (+) of the
paging amplifier for mono mode.
Cat 5 Ethernet Cable
Note
: Ethernet
port is on the
side not shown.
+
*
*Note
: The positive (+) wire coming
from the speaker may be red or white.
The negative (-) wire is black.
Optional 2 Speaker Configuration
(802.3at mode)
8 Ohms
Standard 1 Speaker Configuration
(802.3at mode)
8 Ohms
+
+
*Note
: 16 gauge (AWG) wiring is recommended.
If the speaker will be routed outside, then CyberData
suggests using CL2 or CL3 certified wiring.
*Note
: If you are using 16 gauge (AWG)
wiring, the maximum recommended
length of the wiring to each horn should
be 25 feet or less from the amplifier.
2 speakers in parallel (4 Ohm total)
Twist wire nuts
Note
: The IP66 Analog Horn (011471) comes with a 3.28 foot cable,
which can be connected directly to the amplifier. If the wiring is
greater than 3.28 feet, then it is suggested to use solder and heat
shrink tubing to fasten the additional wires. Twist wire nuts can be
used as an alternative if it is protected sufficiently.
011471 IP66 Analog Horn
(sold separately)
011471 IP66 Analog Horn
(sold separately)