CX ConstruX, Руководство пользователя

Страница: 15 / 23

15
SETTING THE CUTTING DEPTH
The cutting depth of the blade should be set to
suit the thickness of the material being cut. The
cutting depth should be approximately 1/8"
(3 mm) greater than the thickness of the
material being cut.
1.
Turn the depth adjustment knob (1) in a
counter clockwise direction (Fig. 6).
2. Pull the sole plate (2) downward until the
correct amount of the blade is protruding
below the sole plate.
3. Lock the sole plate at the correct depth by
turning the depth control knob clockwise.
NOTE: Make a test cut on a scrap workpiece to
verify the depth setting.
BEVEL CUTTING
The sole plate can be tilted to provide bevel cuts
from 0°
–45°.
Adjusting the sole plate angle
1. Turn the bevel angle locking knob (1)
counter clockwise (Fig. 7).
2. Rotate the sole plate (2) to the desired
angle as shown on the bevel gauge (3).
3. Lock the sole plate at the correct angle by
turning the bevel angle locking knob in a
clockwise direction.
NOTE: Make a test cut on a scrap workpiece to
verify the bevel angle setting.
Setting the 0° stop
Before making right angle cuts, the 0° stop must
be adjusted.
1.
Set sole plate angle at 0° and lock it into
position.
2. Make a test cut.
3.
Check the cutting angle with a carpenter’s
square. If the cut is not square, readjust the
sole plate angle until it is square.
4. Once the sole plate is producing a square
cut, loosen the adjusting lock nut (1) using
a 9/32" (7 mm) wrench. Turn the set screw
(2) clockwise using a #2 Philips
®
screwdriver until it touches the sole plate
(Fig. 8). While holding the set screw with
the screwdriver, tighten the lock nut.
NOTE: The set screw may have to be loosened
to allow the sole plate to be set at 0°.
ASSEMBLY AND OPERATING
Fig. 6
Fig. 7
Fig. 8