CX ConstruX, Руководство пользователя

Страница: 14 / 23

14
INSTALLING A BLADE
WARNING: Always remove the battery
from the tool before installing or removing a
blade or adjusting the saw in any way.
1.
Place your right thumb on the shaft-locking
button (1) (Fig. 3).
2.
Place the socket end of the blade wrench
(2) on the blade screw (3) (Fig. 4).
NOTE: The blade wrench is stored on the front
of the motor housing just above the sole plate.
3.
While pressing the shaft-locking button,
rotate the blade wrench clockwise until the
blade-locking button engages the blade
shaft. Continue turning the blade wrench
clockwise to remove the blade screw and
the large washer (4).
NOTE: The blade screw has a left-handed
thread and must be turned clockwise to be
removed.
4.
To place blade onto the motor shaft, rotate
the blade guard lever (5) forward and slide
the blade (6) through the slot (7) in the sole
plate until it fits over the motor shaft (8)
(Fig. 5).
NOTE: Make sure the blade teeth are pointing
forward at the bottom of the blade.
5.
Place the large flat washer (4) onto the
motor shaft.
NOTE:
Make sure the flat sections of the large
washer fit over the matching flat sections on the
motor shaft.
6.
Insert the blade screw (3) through the large
flat washer and thread it
counter-
clockwise into the end of the motor shaft.
7. Lock motor shaft using the shaft-locking
button and firmly tighten the blade screw
using the blade wrench (2).
NOTE: Make sure the screw is NOT cross-
threaded and that the blade does not wobble
when turned by hand.
ASSEMBLY AND OPERATING
!
Fig. 3
Fig. 4
Fig. 5