P/N IM-WRA-3 Rev. A
2012 Commercial Wireless Systems International, LLC.
18
After the annunciator is enrolled and communicating with the network select the signal survey screen
in the info and maintenance menu as explained in section seven of this manual. The survey screen
will look as shown below when first viewing it.
Survey Screen before First survey
The word “ready” indicates the annunciator has communications with the network. If “not ready” is
displayed the annunciator will not perform a survey as it is not in communication with the CP-
3000A(DA) or an enrolled repeater.
Press the SIGNAL SILENCE button and the annunciator will beep and the following screen will be
displayed.
Signal Survey after first survey
The Linked to I.D. shows the last two characters of the repeater or CP-3000A(DA) the annunciator is
linked to. The next line shows if the survey is good or bad based on a percentage of signal strength
read during the survey signal communication. A number of 68% or higher will display a “Good
Survey” message and the sounder will beep twice. Anything less than 68% will display a “Bad
Survey” message and the sounder will emit a 2 second continuous tone. Press the SIGNAL SILENCE
button to perform additional surveys. The user should wait 2 seconds after the survey result prior to
conducting the next survey. 5 or more good surveys in a row should be received before accepting the
location as being good to mount the annunciator. If a bad survey is received try moving the
annunciator until 5 good surveys in a row are received. Once an acceptable location is found the
annunciator can be mounted as outlined in the installation section of this manual.
Signal Survey
Linked to I.D. xx
Good survey: xx%
ACK>
Charger: 4205 mv (!)
Signal Survey
Ready
ACK>
