P/N IM-WRA-3 Rev. A
2012 Commercial Wireless Systems International, LLC.
14
Multiple events can be scrolled using the ACK/STEP and PREVIOUS buttons. Pressing RESET will
exit system test mode otherwise the system will automatically exit test mode 4 hours after being put
into test.
Section 6 – Programming
6.1 General
The annunciator must be programmed with information about the installation in order to display
alarms, supervisory and troubles correctly. A checksum trouble indicates the annunciator does not
have the same information as the CP-3000A(DA) it’s enrolled into. The annunciator must be
programmed to clear this trouble condition. Programming is accomplished by downloading installation
information from the CP-3000A(DA) using the WRA-3 programming pc application and uploading it to
the annunciator as explained in this section.
When the annunciator is first enrolled into the CP-3000A(DA) it will display a checksum bad trouble
message because its device and programming information does not match the CP-3000A(D). After
the annunciator is programmed the checksum can be cleared. There are however several installation
changes which will initiate a checksum bad trouble and require the annunciator(s) to be
reprogrammed.
The following changes will cause a checksum trouble and require reprogramming of the
annunciator(s):
1. A change to any of the editable parameters of any device or repeater on the device edit
screen of the CP-3000A(DA). The checksum will occur after saving the change(s).
2. Enrolling or deleting a device, annunciator or repeater on the CP-3000A(DA).
3. Changing the supervisory on/off setting for alarm C on the CP-3000A(DA).
4. Changing the point I.D. of a device. Deleting and enrolling the same device would cause
this.
Note: It is advisable to program the annunciator after the entire installation and zone
programming is complete.
Changing any other programming options on the CP-3000A(DA) will not cause a checksum trouble.
6.2 WRA-3 Software programming tool
The WRA-3 programmer is a Windows PC application (WRA3Programmer-1.0.0.exe) used to
program the WRA-3 with the current installation information. The WRA-3 programming tool is
included in the WRA3-PK programming kit sold separately. The kit includes the software, micro sd
card and usb adapter. The WRA-3 programming tool is compatible with Windows XP 32 bit, Windows
7 32/64 bit and Windows 8 32/64 bit. Double click the installation program and follow the prompts. A
desktop icon will be created.
6.3 Programming the WRA-3
When the programming tool installation is complete double click the WRA-3 Programmer desktop
icon. The first step is to download the installation information from the CP-3000A(DA). Connect a
USB cable from the computer to the CP-3000A(DA). Refer to the CP-3000A(DA) for the connector
location.
