Cwejman S1 MK2, Руководство пользователя

Страница: 10 / 52

6
Now begin to experiment:
- Turn the FILTER MIX knob in the MASTER AMP section in position LPF or MMF to hear signals of all
oscillators.
- Change the waveforms and tunings of the oscillators.
- Change the setting of the LPF- and MMF sections (CUTOFF, Q-PEAK, POLE, MODE) and move
the FILTER MIX knob in the MASTER AMP section. See how timbres are changing?
- Turn up the CUTOFF MODULATION (CM) knobs and experiment with the ENVELOPE GENERATOR
settings to add dynamic timbre changes to the sound.
Experiment with the parameters and try to become familiar with the S1. If something might behave
unexpectedly, please be patient. All related issues will be explained in this manual and with some practice,
you will soon be able to manage the S1 and create a universe of great sounds.
Patchbay
Master Controller
The Master Controller section determinates the master frequency and/or modulation depth to all modules
coupled to it, such as oscillators and filters. The four knobs are easy to understand:
MODULATION LEVEL is pre-patched to the LFO output and determinates the master modulation depth being
aplied to the incomming pitch CV (CV1), hereby modulating all oscillators and filters connected to the master
CV bus.
GLIDE determinates the time to glide from one note to another in 5 octave span.
TRANSPOSE is the master octave setting (± 3 octaves).
FINE TUNE (± 3 semitones).
The three MASTER CV switches disconnect the corresponding
oscillator from the incomming pitch CV. The oscillators are not
tracked anymore by an e.g. keyboard, thus allowing the creation
of sounds that are not related to a tonal scale.
All oscillators FM LEVEL (controlled by knobs) are calibrated (1 Volt/octave) and can be controlled by an
external sequencer or other CV source with calibrated 1Volt/octave signal.
MODULATION INPUT sockets; the inputs for individual
frequency control of the three oscillators are internally pre-
patched to the LFO's output, OSC1's output and OSC2's
output (as you can see on the labelling of these sockets).
The LFO's output is also pre-patched to the modulation
input for the master controller.
As we mentioned before, the S1 is a semi-modular system. All modules inputs and outputs are pre-patched
and can be altered or added by the use of patch-cords. To make the use of the patching capabilities most
easy as possible, there is a specific legend used on all sockets:
- Audio and CV outputs are revealed by red surround.
- Inputs are labelled in white text.
- Where an input is pre-patched internally, its source
is labelled red in a white box. These internal patches
are bypassed as soon as you insert a plug.
Since all outputs all short circuit protected,
there is no danger to couple output to output.