Page 24 of 42
REMOVAL OF BURNER UNIT
The main burner unit can be removed if required for repair or servicing by removing by
following the below steps carefully.
1.
Remove the front shelf.
2.
Disconnect the gas supply and cap the inlet pipe to ensure there are no leaks.
3.
Remove the screws in the lower burner tray.
4.
Remove the screws in the side plates and remove the left plate.
5.
The remote magic eye, the recharge socket and the manual switch panel must be
disconnected from the black box.
6.
The burner tray will now be able to be slid forward and lifted out of the enclosure.
7.
Refit the shelf.
REFITTING THE BURNER UNIT
If the main burner has been repaired or changed this can be refitted into the enclosure by
following these steps:
1.
Remove the front shelf.
2.
Slide in new burner unit.
3.
Refit side plates.
4.
Refit the lower burner screws.
5.
Reconnect the remote magic eye, the recharge socket and the manual switch panel to
the black box.
6.
Reconnect the gas supply.
7.
Check for leaks.
8.
Commission the appliance as shown in Section 6.
