Page 27 of 31
Removing Powders, Soot, Ash or Grit
These should be removed without the use of liquids of any kind. Best
results are achieved by using a vacuum cleaner; to lift the particles
from the surface of the surround, or by blowing or fanning the particles
away with a piece of card.
If, after removing the powder there is still evidence of a staining, this
can be removed by using an organic cleaner mix as stated previously.
Removing Wax
However, in the event of molten wax falling onto the surface, the
following method of removal is suggested. Do not attempt to remove
any spilled wax whilst still molten, attempting to rub away the spillage
will simply spread it across a greater surface area.
Once cooled any heavy globules of wax can be picked away from the
surface. Next place a piece of heavy blotting paper over the affected
area, and run a hot iron over it, the wax which is melted by the iron will
be drawn away from the surface of the surround by the blotting paper.
It may be necessary to repeat this process several times until all the
wax has been successfully removed.
If blotting paper cannot be obtained a heavy-duty kitchen towel or
similar absorbent material will suffice.
Cleaning Metal Components
Bronze metalwork can be kept clean by simply dusting or wiping with a
damp cloth. Where bronze metalwork has become tarnished, a highly
polished finish can be achieved using a cloth and a propriety brass
cleaning fluid - simply follow the instructions given on the container.
(Brass cleaner fluid is available from hardware stores to add an extra
shine.)
Fine (0000 grade) wire wool can be used to remove slight scratches
from brushed steel should they occur. Please note that you must always
rub the metal in the direction of the grain.
Do not rub in a circular motion or across the grain.
In the interest of personal safety, please do not attempt to clean the
metalwork when the fire is ignited or the metalwork is still hot.
Bronze Service and Aftercare Requirements
