Cutler-Hammer Freedom 2100 Series, Руководство по установке и обслуживанию

Страница: 22 / 34

22 I.B. 8926-1A
CAUTION: Brace the panel solidly to avoid breaking
the hinge points. Use a knife or small file to remove
remaining plastic burrs. Install and wire the new
device and re-attach the top of the device panel to
the unit.
Fig. 32 Unit Device Panel
INSTALLING A NEW UNIT
It is recommended that a new unit be installed in a
unit space at the top of a vertical compartment or
directly below an existing unit. Material provided with
the new unit by the factory includes: A divider pan
with integral guide rails, a unit door, hinges, catches
and hardware. Observe the following sequence of
operations for installation.
1. Remove the existing blank door.
2. Position the new unit door over the open space
to ensure the hinges and latches are aligned. If
the spaces differ, the hinges and latches on the
structure must be re-located to match the unit
door hinges and latches. Mount the door, using
the hinge pins provided.
3. Install the new divider pan in the notches
provided in the rear barrier so that it is aligned
with the bottom of the new door. Attach the pan
to the vertical structure channels with one
thread-forming screw on each side.
4. Remove from the vertical bus barrier the flat
plate which covers the stab holes that will align
with the stabs on the new unit. If an optional
labyrinth vertical bus barrier is in place, install an
automatic shutter over the stab cutouts. Follow
the instruction sheet provided with the shutter
kit.