Cutech 40180H-CT, Руководство пользователя, Страница: 25 / 35

25
OPERATIONS (cont.)
PUSH BLOCKS
CAUTION! A set of push blocks (A) should be used whenever possible to minimize all danger
to your hands. SEE FIG 22
FIG 22
WARNING! ALWAYS USE PUSH BLOCKS WHEN PERFORMING SURFACING
OPERATIONS AND NEVER PASS YOUR HANDS DIRECTLY OVER THE CUTTERHEAD.
JOINTING AN EDGE
This is the most common operation for the jointer. These cuts are made to square an edge of a
work-piece. Set the guide fence square with the table. Depth of cut should be the minimum
required to obtain a straight edge. Hold the best face of the piece firmly against the fenc e with
push blocks throughout the feed. SEE FIG 23.
FIG 23
SURFACING / PLANING
Surfacing is similar to the edge jointing operation except for the position of the work piece. For
surfacing, the major flat surface of the work piece is placed on the infeed table of the jointer with
the narrow edge of the work piece against the fence. The work piece is moved from the infeed
table, across the cutterhead to the outfeed table, establishing a flat surface on the work piece.
A