D160S-T420 Portable
Service Hose Crimper
16
CRIMPING WITH
NOTCHED
T420 PRESSURE PLATE
Note:
Follow the lubrication procedure prior to crimping procedure.
CAUTION:
Failure to lubricate the die set and pressure plate could
result in the die seizing in the cone base.
Step 1:
Make certain that the
Cone Base
is clean and lubricated
prior to inserting the die set.
Step 2:
Select the
Correct Die Set
for the combination of hose and
fitting being crimped.
Note:
Consult your hose and fitting manufacturer for the correct die size
for the combination of hose and fitting being crimped.
Note:
The number etched on the OD of the die ring represents the fully
closed diameter of the die set in millimeters. In addition, the rubber
caged die sets are color-coded for easier identification.
Step 3:
Lubricate the contact surfaces
, both top and outside edges of
the die fingers, with CrimpX oil (supplied with crimper) or a high pressure
molybdenum high pressure grease.
Failure to lubricate the contact surfaces with the correct lubricant
will cause the dies to seize in the cone base, causing damage
to the die set as well as possibly damaging the crimper.
WHEN USING THE NOTCHED T420 PRESSURE PLATE,
FOR USE WITH 90 DEGREE FITTING ONLY,
FOLLOW THESE PROCEDURES:
