D160S-T420 Portable
Service Hose Crimper
9
INITIAL SET UP
FOLLOW THESE STEPS BEFORE YOU USE THE CRIMPER
FOR THE FIRST TIME.
The D160S-T420 Portable Series hydraulic hose crimper paired with
either a ValPower® Hand Pump, Pneumatic Pump or Electric Pump
make the perfect combination for portable crimping requirements.
Weighing only 85 lbs and mounted on a convenient carrying frame, this
62 tons of crimping force can be carried to almost any location where
service is required.
• If the D160S-T420 series crimper is going to be used in the shop is
recommended to mount the crimper on a sturdy workbench in a well-
lit area. Workbench should be able to support the crimper, pump, and
components weight.
• The crimper should be mounted close enough to the edge of the
work surface so that hose will not contact the bench or work surface
while crimping. There must be enough clearance for the hose to align
perpendicular with the cone base, or the dies will not seat properly and
the crimps will not be accurate.
• Manual Pump 10,000 psi, Pneumatic Pump 10,000 psi or Electric
Pump 1HP motor 110V single phase 15 AMP, ValPower® offers rugged
industrial duty hydraulic power units that will meet the demanding
requirements of industrial users. Both manual and air pumps have
aluminum reservoirs and all electric models have steel reservoirs to
withstand the temperature and service conditions of industrial use.
• A 10,000 psi hose and quick disconnect fitting has been included
with the crimper to connect to any of the optional power units to the
D160S-T420 cylinder port.
