Custom Crimp CC25, Руководство оператора

Страница: 5 / 9

5 Page
CRIMPING WITH THE CC25 CRIMPER
LOCKING TAB
Select the correct die set for the combination of
hose and fitting being crimped. Consult the hose
and fitting manufacturer’s specifications for the
correct die to use.
Insert each die finger individually making certain
that the die size (number stamped on the face of the
die) faces the front of the machine. The die should
click into place when it is properly positioned.
Release the micrometer locking tab, and adjust the
micrometer to the hose and fitting manufacturer’s
recommended setting.
Note on Micrometer Settings
Each 100 on the Micrometer represents 1 mm
above the closed diameter of the die set. For
example, with a 57mm die installed and the
Micrometer set at 150 the finished crimp
diameter would be 58.5 mm (57mm + 1.5mm)
Insert the hose and fitting in the crimper head and
press and hold the start button. When the crimper
reaches the correct diameter, the crimper will shut
off. Release the start switch and remove the hose
and fitting. When possible, the hose fitting should
be centered axially in the die set to assure a uniform
crimp with minimum taper.
Measure the finished diameter to be certain that it is
within manufacturer’s specifications. If the finished
diameter is not within specifications, see calibration
instructions.