Custom Audio Electronics VKP112, Руководство пользователя

Страница: 15 / 48

(1) NOTE: If the printer has a USB interface and the cable is plugged into the printer connector, the
message USB will appear next to the address assigned by the Host to the USB peripheral device in
use (see
fi g. 1.3).
(2) NOTE: If the printer has a notch sensor (opt. 0103 ) this parameter can have different values.
These values derive from the results of the notch sensor autocalibration phase, which can be made,
at the user request, at the end of the font test.On the ticket is printed “notch threshold autocalibra-
tion”, and then the printer analizes a certain number of notches. After this test it’s possible to get 2
voltage values “Vin maximum voltage” and “Vin minimum voltage” which give the notch threshold
value to memorize.
3) NOTE: If the printer has an USB interface, the serial interface con fi guration parameters are not
displayed.
(4) NOTE: This parameter is displayed if the printer has an USB interface; it’s used to identify univo-
cally the USB printer by a numerical address code, if on the PC are connected two printers that are
the same models for example two TPTCM60-U.
(5) NOTE: This parameter is displayed if the printer has an USB interface. The Status Monitor is an
additional printing driver component that allows the printer status monitoring. It must be enabled only
if it was installed the Status Monitor speci
fi c driver.
1.3 CONFIGURATION
This printer permits the con fi guration of default parameters. The printer’s con fi gurable parameters are:
•
Printer emulation
: ESC/POS™, CUSTOM TPT D .
For serial interface
:
•
Baud Rate
: 57600, 38400, 19200, 9600 D , 4800, 2400, 1200.
•
Data length
: 7, 8 bits/char D .
•
Parity
: None D , even or odd.
•
Handshaking
: XON/XOFF D or Hardware.
For parallel interface
:
•
Select line
: Select D , Ticket Present, Paper Low.
•
Fault line
: Error D , Ticket Present, Paper Low.
•
USB address N.
: 0 D , 1, 2, 3, 4, 5, 6, 7, 8, 9.
•
USB Status Monitor
: Activated o deactivated D .
•
Autofeed
: CR deactivated D or CR activated.
•
Panel keys
: Activated D or deactivated.
•
Print mode
: Normal D or Reverse.
•
Height mode
: x1 D , x2 or x4.
•
Width mode
: x1 D , x2 or x4.
•
Justifi cation
: Left D , Centered or Right.
With ESC/POS™ emulation:
•
Char/line
: A=58 / B=82 columns D or A=82 / B=104 columns
With CUSTOM TPT emulation
:
•
Font Size
:
34 col. 52 col. 104 col.
24x32 16x24 8x16
1. INSTALLATION AND USE
User Manual
VKP112 1-3