Custom Audio Electronics TPTCM, Руководство пользователя

Страница: 18 / 124

1. INSTALLATION AND USE
TPTCM
4 1-
3
1
2
4
1.4 HEXADECIMAL DUMP
This function is used to diagnose the characters received through the communication port; the characters are
printed out both as hexadecimal codes and ASCII codes.
Once the self-test routine has finished, the printer enters Hexadecimal Dump mode. The printer remains in
standby until a key is pressed or characters are received through the communication port.
For every 10 characters received, the hexadecimal and corresponding ASCII codes are printed out (if the
characters are underlined, the receive buffer is full).
Shown below is an example of a Hexadecimal Dump:
48 65 78 61 64 65 63 69 6D 61
Hexadecima
6C 20 64 75 6D 70 20 66 75 6E
l dump fun
63 74 69 6F 6E 20 30 31 32 33
ction 0123
34 35 36 37 38 39 61 62 63 64
456789abcd
65 66 67 68 69 6A 6B 6C 6D 6E
efghijklmn
6F 70 71 72 73 74 75 76 77 78
opqrstuvwx
79 7A
yz
1.5 MAINTENANCE
1.5.1 Changing the paper roll
Depending on how the printer
“Paper Autoload”
parameter is set, one of two procedures must be followed:
If enabled:
Position the paper roll (1), so that it unrolls correctly as shown in fig. 1.4; insert the paper into the
infeed slot (3) and wait for the roll to load automatically.
If not enabled,
proceed as follows:
1) Position the paper roll (1), so that it unrolls correctly as shown in fig. 1.4;
2) Raise the print head by lifting the lever (2) in the direction indicated by the arrow;
3) Insert the end of the paper roll into the infeed slot (3) and have it pass beyond the print head;
4) Lower the head lever (3) and press the LINE FEED key (4), so that the paper will feed a few centimeters
out of the printer.
(Fig.1.4)