Custom Audio Electronics TPTCM, Руководство пользователя

Страница: 17 / 124

1. INSTALLATION AND USE
TPTCM
3 1-
1.3 CONFIGURATION
This printer permits the configuration of default parameters. The printer’s configurable parameters are:
•
Printer emulation:
ESC/POS
™
, CUSTOM TPT D .
If a serial interface is present:
•
Baud Rate:
57600, 38400, 19200, 9600 D , 4800, 2400, 1200.
•
Data length:
7, 8 bits/char D .
•
Parity:
None D , even or odd.
•
Handshaking:
XON/XOFF D or Hardware.
If a parallel interface is present:
•
Select line:
Select D , Ticket Present, Paper Low.
•
Fault line:
Error D , Ticket Present, Paper Low.
•
USB address N. :
0 D , 1, 2, 3, 4, 5, 6, 7, 8, 9.
•
USB Status Monitor :
Activated o deactivated D .
•
Autofeed:
CR deactivated D or CR activated.
•
Panel keys:
Activated D or deactivated.
•
Print mode:
Normal D or Reverse.
•
Height mode:
x1 D , x2 or x4.
•
Width mode:
x1 D , x2 or x4.
•
Justification:
Left D , Centered or Right.
With ESC/POS
™
emulation:
•
Char/line: G
A=32 / B=42 columns D or A=42 / B=56 columns
H
A=58 / B=82 columns D or A=82 / B=104 columns
With CUSTOM TPT emulation:
•
Font Size:
G
.l o c 8 1 .l o c 8 2 .l o c 6 5
2 3 x 4 2 4 2 x 6 1 6 1 x 8
H
.l o c 4 3 .l o c 2 5 .l o c 4 0 1
2 3 x 4 2 4 2 x 6 1 6 1 x 8
•
Speed/Quality:
Normal
D
, Draft or High Quality.
•
Paper Autoload:
Deactivated
D
or Activated.
•
Reset buffer:
Not implemented, At paper end
D
.
•
Print density:
Normal
D
, Light, Very light, Dark, Very dark, Double copy.
General notes:
1)
The parameters marked with the symbol
D
are the default values.
2)
The symbol
G
indicates the TPTCM60x
3)
The symbol
H
indicates the TPTCM112x
4)
Settings remain active even after the printer has been turned off.
The settings made are stored in EEPROM (nonvolative memory).
During power-up, if both the LINE FEED and FORM FEED keys are held down, the printer enters configuration
mode and prints-out the setup report; it will remain in standby until a key is pressed or characters are received
through the communication port (see Hexadecimal dump).
When the LINE FEED key is pressed, the printer skips the setup mode and terminates the Hexadecimal dump
function.
When the FORM FEED key is pressed, the printer enters the parameter entry mode.