Custom Audio Electronics FX3850N, Руководство пользователя

Страница: 13 / 14

9. Troubleshooting
Possible Cause Solution
No Display
Batteries not charged or bad
connection or wrong connection
Charge fully
Check connections
Check battery position
Check connections
Replace batteries periodically
No Dial Tone
(with timer running)
Connect line cable to main base
No Dial Tone
Display shows searching
No Dial Tone or Intercom
Three Beeps are heard The Line is busy or the
handset you are calling is Busy Check all handsets are
disconnected (Off)
Ringer not working
Ringer volume too low
Ringer turned off
or Adjust volume
Flash or Call Waiting does not
work
Earpiece Volume too high/low Adjust incoming sound
Caller ID or Message Waiting
not working
Service not connected
Caller cant hear you or
microphone cuts out during calls
Handset cuts out even when
charged
Microphone Muted
(be carefull not to bump
the mute during calls) During calls press mute once to
mute and again to unmute the
microphone
Caller ID or Message service
must be subscribed to on this line
by your telephone line service
provider (charges may apply)
Old Batteries
Loose Batteries
Phone line faulty or phone
Cable unplugged
Move Closer
Check power connections
Re subscribe (see instructions)
Press ringer key 3 seconds
At standby press volume then
number 1,2,3,4 or 5
Press Redial for three seconds
to select LONG or SHORT
flash (Default is LONG for NZ)
During call press volume
then number 1,2,3,4 or 5
Wrong Flash setting
(see instructions)
Too far from base
Main power supply
or Subscription lost
HANDY HINT
AT ANY TIME TO EXIT A PROGRAM MODE OR RETURN
TO MAIN MENU WAIT TEN SECONDS
10 Technical Data
Dect 1880-1900 MHz
Range: up to 300 m in open space
up to 50 m in buildings
Dialling options: DTMF (tone)
Batteries: 2 x 1.2V, 600 mAh AAA Type NiMH rechargeable
Max. standby time: approx. 100 hours
Max. talk time: 11 hours
Power supply base adaptor: /230V , 50 Hz
Memories 10 indirect with max. 25 digits
11
For more information contact
www.product-support.co.nz