Cushman 898627, Руководство по обслуживанию

Страница: 28 / 186

6 MAINTENANCE
GB-28
6.26 ELECTRICAL SYSTEM _____________________________________________________
General precautions that can be taken to reduce
electrical problems are listed below.
1. Make certain all terminals and connections are clean
and properly secured.
2. Check the Interlock system, and fuses regularly.
If the Interlock does not function properly and the
problem cannot be corrected, contact an authorized
Jacobsen Dealer.
3. Keep the wire harness and all individual wires away
from moving parts to prevent damage.
4. Check the battery and battery charging circuit.
5. Do not wash or pressure spray around electrical
connections and components.
6. Circuits are protected by fuses located under the
front cowl and a fuse located near the cooling fan.
Figure 6S
6.27 DASH PANEL _____________________________________________________________
The dash panel contains gauges and instrument lights to
display unit functions. Maintenance of the panel is limited
to replacing bulbs and setting the DIP switches. Remove
the four screws securing the instrument panel to the
dash.
Pull panel out, tilt panel forward and disconnect electrical
connector for easier access to rear of panel.
Light Bulb Replacement:
1. Determine which bulb needs to be replaced.
2. Rotate bulb holder 1/4 turn counter-clockwise and
pull up and away from dash panel.
3. Replace old bulb with a new bulb of equal type.
Location ........................... Replacement Bulb
A Voltmeter ............................C658
B Temperature Gauge............C658
C Fuel Gage ...........................C658
D Hour Meter..........................C658
E Tachometer.........................C161
F Left Turn Signal ..................C161
G Oil Pressure ........................C161
H Glow Plug ...........................C161
J Brake Fluid .........................C161
K Right Turn........................... C161
L Parking Brake..................... C161
M High Beam.......................... C658
N Alternator / Battery ............. C161
4. Place bulb and holder back into panel. Turn holder
1/4 turn clockwise to secure into panel. Ensure base
of holder is properly seated in panel.
CAUTION
Always turn the ignition switch off and remove the
negative battery cable (Black) before inspecting or
working on the electrical system.
!
Dash Panel,
Fuel Pump
& Ignition
Accessary
Heater
Accessary
Wiper,
Dome Light &
Back-Up Alarm
Power Port
Brake Light,
5th Wheel Brake
Flashers &
Horn
Headlights
15 A
10 A
10 A
15 A
20 A
10 A
10 A
10 A
Radiator
Fan
Diesel Engine
Gas Engine
ECU, Main Relay,
Injectors
Heater
Accessary
Wiper,
Dome Light &
Back-Up Alarm
Power Port
Brake Light,
5th Wheel Brake
Flashers &
Horn
Headlights
15 A
10 A
10 A
15 A
25 A
Dash Panel,
ECU, Fuel
& Engine Coils
20 A
15 A
Backup Alarm
Shift Switch 10 A
ECU 10 A
10 A
Accessary 10 A
10 A