5
5.3
Remote control - use
To use the remote control unit, insert batteries into the battery compartment of the remote control unit.
Ensure that the POWER buttons on the TV and DVD player are switched on. Point the infrared
transmitter on the remote control towards the remote control sensor on the DVD player and press the
function button of choice. Allow time for the remote to respond before pressing another button.
Use the remote handset no more than 6m from the remote sensor and at an angle of no greater than 30°.
6.
CONNECTING DVD PLAYER
7.
CONFIGURE THE TV
The DVD player is set to UK PAL TV type as standard.
7.1
Place the DVD player horizontal on a flat level surface.
7.2
Connect the DVD player to your TV and / or audio system (as shown in the previous diagrams), plug in
and switch on at the mains.
7.3
Insert the batteries into the remote control.
7.4
Press the POWER button
on the DVD player
to turn on the player and turn on the TV and amplifier (if
connected).
7.5
Select the video mode (AV) for the TV. If there is more than one video channel (AV1, AV2, etc) select the
source that the DVD player is connected to. See the TV instruction manual for tuning instructions if the set
does not automatically tune.
CAUTION !
ALL EQUIPMENT MUST BE TURNED OFF AND DISCONNECTED FROM THE MAINS BEFORE
INSTALLATION
Stereo
System
To
audio
inputs
of
the
amplifier
White
Red
White
Red
To
SCART
input
To
SCART
output
SCART
Cable
(
not
included
)
S
-
Video
cable
(
not
included
)
To
S
-
Video
input
To
S
-
Video
output
OR
Television
VIDEO
VIDEO OUT
S-VIDEO
R
L
AUDIO
SCART OUTPUT
COAXIAL
DIGITAL OUT
AV
Cable
(
not
included
)
AC 110-240V~
50/60Hz
Co-axial Audio cable
(
not
included
)
To Dolby/AC-3 input of the decoder
