NEED ASSISTANCE?
•
844.278.4357
•
RA
•
PAGE 8
Step 17
Locate a spot to install the power switch.
Drill a hole in the panel with a 3/4" drill bit
and wire into place.
WARNING:
Confirm there are no wires
behind the panel prior to drilling.
Important:
Be sure to plug the blue female
wires into the silver male ends and the red
female wire into the bronze male end.
Step 16
On the driver side, plug the rear actuator
(red / black) into the running board and
pull the extra wire back into the vehicle.
Plug the LED light wire (brown / tan) into
the LED light and secure it to the mounting
bracket tab with the supplied jam nut.
Once all the wiring is installed, cover the
wires with slit loom for extra protection.
Repeat for the passenger side of the vehicle.
Refer to step 12 for wiring call out.
