3. Battery Pack, Charger Port and Charger
The 350 series electric scooter comes with a 24 Volt/10 AH “Plug and Play” battery pack.
The battery pack is installed at the factory, and it is located under the deck plate. To
access the battery, if necessary, turn the power switch to the OFF position (fig. a),
unscrew the “D” ring bolt located beneath the power switch at the front center of the
main deck and remove the deck.
Electro Drive Charger
The 350 series scooter comes with its own
“Electro Drive Smart Charger” that connects
with an easy-access charger port for recharging
the batteries. This charger unit has a light
which shows battery charge status. Refer to the
instructions that appear on the charger unit.
How to Charge the Batteries
1. Important: Make sure the power switch on
the scooter is turned to the OFF position.
2 . Insert the Battery Charger’s Round Connector
into the Charger Port (fig. b) located below the
power switch on the scooter and then plug the
charger electric cord into a standard, grounded
110V AC outlet.
3. Let the batteries charge until the charger
light turns solid green, then unplug the
charger from the scooter and the AC outlet.
Ca u t i o n :
Batteries “like” to have a full charge,
so be sure to recharge them fully after each
ride. If you leave them in a run-down condition
and do not quickly recharge them, it will shorten
their life expectancy. Charger may get warm to
the touch, so make sure you charge them in
an open area and do not lay anything on the
charger unit itself. Although you cannot
over-charge the batteries using the Currie
“Smart Charger”, we recommend you do not
leave the charger plugged in for more than
24 hours maximum.
Use only the Currie Electro Drive Smart
Charger to charge the 350 series batteries.
Using any other charger may damage the
PAGE 7
figure a
figure b
