If the throttle does not operate as described, DO NOT RIDE THE SCOOTER. Call the
CTI Customer Service line at: 800-377-4532 for further instruction.
7.
Tire Pressure:
The correct tire pressure for the 350 series tires
(size: 12 1/2” X 2 1/4”) is 35 psi. Check it with a reliable tire pressure gauge and
inflate as needed. Caution: Do not use an unregulated compressor when inflating
your tires. Gas station compressors typically deliver too much volume for bicycle type
tires, and may cause them to burst.
Caution: Three Items for Riders to Double Check:
1. Before every ride, check the Handlebar Quick Release Lever to make sure it is
locked tight in the “Closed” position. (see instructions on page 5 and 6)
2. Also check your tire pressure regularly. Do not ride on under inflated tires. All bicycle
type tires lose small amounts of air naturally.
3. Test your brake operation before every ride to insure safe and reliable
stopping performance.
II. ASSEMBLY, ADJUSTMENT AND OPERATION OF ALL COMPONENTS
1. Handlebar Assembly and Adjustment
Caution:
The 350 series scooter is equipped with an “Easy Fold” handlebar and stem
a s s e m b l y. Take care not to pinch your hand or any of your fingers in the hinge when you are
raising and locking the handlebar in place. Also be careful to avoid pinching or crimping the
brake and throttle cables in the hinge whenever you raise or lower the handlebar.
a. To raise and lock the handlebar
p r o p e r l y, first lift the handlebar to
its upright position while Ta k i n g
hold of the Quick Release (QR)
lever and pulling back the center
pin (see figure a) so that the top
part of the handlebar hinge makes
full contact with the bottom part.
Then let the center pin slide back
into its locked position.
b. With the QR lever in its “open”
position (see figure b), lift the QR
bolt up and into the slot in the
upper hinge plate. Then flip the QR
lever down into its fully locked
and closed position. The cam
PAGE 5
figure a
