Wireless Adapter (WA100-PM)
WA100-PM Model Variants
The model number WA100 was the original version of the adapter and is no longer sold. The WA100-PM model monitors and
measures the power consumption of the connected lighting load. The
WA100-PM
reports power measurement data to CSM.
Unless specifically noted, all references to the WA100-PM also apply to the WA100.
DIP switch settings
DIP switch settings enable the WA100-PM to operate appropriately for the type of lighting control it provides and the
type of device(s) to which it is connected and adapting for wireless communication.
Set DIP switches based only on the
devices that are physically wired to the WA100-PM.
There are two primary adaptation modes to choose from as determined by the DIP switch 1 setting.
Configure DIP switch settings only as shown in this instruction.
Incorrect switch settings will cause unexpected
operation.
After
you change DIP switch settings, you need to press the blue
Reset
button for
3 seconds
to reset the unit. Release
the button when the green Joined and red Error LEDs begin flashing.
•
In Light Adapter Mode, the settings are for the type
of lighting control that is available on the connected
driver, and/or the sensor type(s) connected to the
WA100-PM.
•
In the Switch Adapter Mode, settings are for the
connected switch type and whether the WA100-PM
is connected to a light.
Fig. 1: DIP switch location
Switch Adapter
Driver type
switches 1 to 4
On/Of f + 0-10V dimming
On/Of f (no dimming)
Alternate Switching
Bi-Level
No Driver
(sensors only)
Sensor
switches 5 & 6
Occupancy
Photosensor
Both
None
Light
Adapter
Switch type
switches 1 to 4
Dimming
On/Of f (no dimming)
Alternate Switch
Bi-Level
Light output ID
5 & 6
Light + Switch
(driver & switch
are same type)
No Light
(switch only)
Mode
DIP Switch Positions:
Range Extender*
no light, no sensor
*Valid only with firmware v2.6 or higher
Fig. 2: DIP Switch Table — See
DIP switch Mode descriptions
for information about each option.
2
