Getting Started |
JetTouch
®
Workstation
| 5
4 |
JetTouch
®
Workstation
| Diagrams
Getting Started
This section outlines basic features and functions of the JetTouch workstation.
Powering ON
To turn the unit
ON
:
• Ensure the power cord is firmly
plugged into a grounded outlet.
• Press the
power switch
.
The system performs a confidence-test
routine and prompts the
SYSTEM START
screen.
Signing ON the System
To sign onto the system and begin processing notes:
1. Select a processing type on the
SYSTEM START
screen.
2. The
SYSTEM SIGN-ON
screen appears. Enter the operator or supervisor ID using the
numeric keypad and press
ENTER
.
Two USB ports
Default processing types
Power
switch
Left side view
UPS Battery
If power failure occurs, the UPS battery
gives users the opportunity to perform
a controlled system shutdown, which
reduces the risk of hard-drive failure. The
battery is located on the bottom of the
unit, as shown at right.
LED Indicator
The LED indicator below the touch screen
communicates important information
about the machine’s power status.
Indicator statuses are described in the
following chart.
Lithium battery installed.
Only replace battery with battery of same type.
Follow local environmental protection laws and regulations when
discarding used batteries.
Indicator
Status
System
Status
External
Power
UPS Battery
Powering
Up
Off
Off
Off
Present
Not allowed
Green
Off
On
No influence
Allowed
Blue
On
On
No influence
Not required
Blue/flash
On
Off
Activated
Not required
Green/
rapid flash
On
Off
Running at low
capacity
Not required
The system default supervisor ID and password is
1111
.
This ID may be deleted once a new supervisor is created. Press
PASSWORD
MAINTENANCE
on the
SUPERVISOR MENU
to add, change or delete IDs and
passwords.
Use this 9/09
Helv. Bold
Oblique
41.29
Customized processing types
created in
SETUP
