SECTION 2 JETSORT 1000 Series OPERATION
4.
ENTERING AND CORRECTING DECLARED BALANCE
INFORMATION
The Declared Balances for both Batch and Sub-Batch must be turned On in Set-Up.
Enter data using the numeric keypad and press ENTER twice to accept the information
and return to a Batch Waiting condition.
When entering values for Batch Declared Balance, Sub-Batch Declared Balance and
Miscellaneous Media, the ENTER key works like a calculator. Entering a positive value,
followed by the ENTER key will add the value to previously recorded values. Entering a
value, followed by the – (minus) key will deduct the value from the previously recorded
values. Once your entered value is correct, press the ENTER key a second time to
record the new value and leave the screen.
JetSort will display the difference between coin/currency total and Batch Declared
Balance or Sub-Batch Declared Balance, along with Even, Over or Short Status, after
ending a Batch.
To subtract from balance values, enter the difference through the numeric keypad and
press the – (minus) key. The adjusted balance will now be displayed. Press the ENTER
key to accept and return to a Batch Waiting condition. Data can only be corrected while
in a Batch Waiting condition.
5.
ENTERING AND CORRECTING MISCELLANEOUS MEDIA
INFORMATION
If miscellaneous media (currency, checks, miscellaneous) is turned On in Set-Up, enter
data via the numeric keypad and press the ENTER key twice to accept and return to a
Batch Waiting condition. Press the CLEAR key to correct and re-enter numeric values
not yet recorded.
If in the middle of a Batch, the operator needs to correct media entered, press the
MEDIA key when the screen says Batch Waiting. The screen will indicate the media
previously entered. At this point, the operator can input the correct ID via the keypad
and Press ENTER to accept the entry. When the screen says Batch Waiting, the
operator can resume sorting. Data can only be corrected while in a Batch Waiting
condition.
To subtract from balance values, enter the difference through the numeric keypad and
press the – (minus) key. The adjusted balance will now be displayed. Press the ENTER
key to accept and return to a Batch Waiting condition.
Rev. D
Page 27
Form # 022-7240-00
