12
The statistical functions are reached by pressing the “Information” key. Repetitive presses of the
“Statistics” key will cycle through the standard statistics mode until cycled back to time of day display.
Once either of the Information menus is entered the information shown for each display is outlined
below:
• Flow Rate (Meter mode only) -
The display shall show the
current flow rate of the water passing through the control. The
display will first show “FLOW” for two seconds and then display
the current flow rate for 10 seconds. The meter factor must be set
properly for flow to be recorded accurately. This circuit board
has a default meter factor of 80 which is the proper setting for use
with Culligan standard 1” meter.
• Today’s Water Usage (Meter mode only) -
This display
will show the accumulated flow of water for the current day. The
value should reset to zero daily at 12:00am. The display will
show “tU” with the gallon value (the x10 should appear when
necessary if the amount counts past 999 gallons; rollover at 10k
gallons).
• Average Daily Water Usage -
This display will show a
running 7-day average of daily water usage. The display should
update daily at 12:00am. The display will show “AVG” with
the gallon value (the x10 should appear when necessary if the
amount counts past 999 gallons; rollover at 10k gallons).
• Number of Regenerations in Last 14 Days -
This display
will show the number of regenerations that have occurred in
the last 14 days. The display will first show “14dAY” for two
seconds and then display the number of regenerations that have
occurred for 10 seconds. The days counter is to be updated at
the programmed time of regeneration for delayed regeneration
settings and at 12:00 AM (24:00) for immediate regeneration
settings. The counter is not to be updated during programming of
time of day if the days setting point is crossed.
• Maintenance Interval (Only available with dip #2
on) -
This display indicates the number of days remaining
of the programmed maintenance interval. When this value
reaches zero, the “MAINT” alert will be activated. This setting
is resettable by holding the regen key for 10 seconds while at
this display, also it will clear the “MAINT” alert. The display will
show “MAINT” for 2 seconds followed by the number of days
remaining for 10 seconds.
Statistic
Functions
FLOW
I8.0
TU I 23
AVG I 23
MAINT
365
I4 DAY
I0
