Programming
The DEFAULT programming menu for a Medallist Filter is outlined in the following table:
Setting
Display
Range Limits Default
Comments
Time of Day
12:00 AM - 11:59 PM
(12hr)
00:00 - 23:59 (24hr)
12:00 PM
12:00
12 / 24 hour function set
with dip #6
*Time of
Reconditioning
Cycle
12:00 AM - 11:30 PM
(12hr)
00:00 - 23:30 (24hr)
2:00 AM
02:00
- Adjust time in 30
minute increments only
*Cycle 1 time
01 - 99 minutes
10 minutes -Always active in Time
Clock Mode
*Cycle 2 time
01 - 99 minutes
- Filter -
02 minutes
-Always active in Time
Clock Mode
*Cycle 3 time
01 - 99 minutes
10 minutes -Always active in Time
Clock Mode (Filter)
*Reconditioning
Cycle Interval
Days - 01 to 99 days
03 days
*Gallons
Capacity
1 - 9,999
870
Active if flow meter is
connected to circuit board
Hidden Programming Menu
(Accessed from service mode by holding the “+” key for 5 seconds)
*Delay /
Immediate
Toggle Delay or
Immediate
Delay
- Locks in a regen signal
after a 3 hour or more power
outage; regen can be set to
go immediate or delay until
the tor;
- Only accessible from
service mode, time of day
display, by pressing and
holding “+” for 5 seconds
- (not in programming menu)
*Lock / Unlock
Toggle Lock &
Unlock
Unlock
- Lock or unlock access to
make program changes
- Only accessible from
service mode, time of day
display, by pressing and
holding “+” for 5 seconds
- (not in programming menu)
• To be saved in EEPROM
Make sure inlet water supply is turned off to unit by placing it on bypass, then supply power to the timer.
The display will power up flashing “12:00 PM” and the motor will energize and cycle the control, without
stopping to the home position. This is required to ensure that the control is in the home position.
NOTE! IMPORTANT!
Connect the flow meter to Accusoft circuit board prior to making
any programming adjustments.
9
01035157 C 10/20
